Simple and clear---16 basic requirements for cold storage installation
发布时间：
2017-10-30
1. The cold storage is installed in a strong and stable place. 2. The cold storage is installed in a place with good ventilation and low humidity, and the cold storage is installed in a place protected from light and rain. 3. The drainage in the cold storage is discharged through the drainage pipe. Water is often drained, so direct the drain to a place where it can flow smoothly. 4. The installation of the combined cold storage requires a horizontal concrete base. When the base is inclined or uneven, the base must be repaired and flattened. 5. The partition wall panel of the combined cold storage should be fixed by the partition wall angle steel. 6. After the combined cold storage body is installed, check the fit of each board seam. If necessary, the inside and outside should be filled with silica gel to seal. 7
1. The cold storage is installed in a strong and stable place.
2. The cold storage is installed in a place with good ventilation and low humidity, and the cold storage is installed in a place protected from light and rain.
3. The drainage in the cold storage is discharged through the drainage pipe. Water is often drained, so direct the drain to a place where it can flow smoothly.
4. The installation of the combined cold storage requires a horizontal concrete base. When the base is inclined or uneven, the base must be repaired and flattened.
5. The partition wall panel of the combined cold storage should be fixed by the partition wall angle steel.
6. After the combined cold storage body is installed, check the fit of each board seam. If necessary, the inside and outside should be filled with silica gel to seal.
7. The combined cold storage is used in the house. When it is installed outside the house, a roof to block sunlight and rain should be installed.
8. The U-shaped pipe is not installed on the drain pipe, and sometimes the unit will be corroded.
9. When the cold storage is in a hot place, not only the cooling efficiency will decrease, but sometimes the storage board will be damaged. In addition, the ambient temperature range to ensure the normal operation of the unit is within 35 degrees. There is also room for maintenance of the unit.
10. When assembling the board, pay attention to the complete sticking of sponge tape on the convex edge of the storage board. When installing the cold storage board, do not collide. Sponge tape sticking position.
11. A U-shaped pipe must be installed on the drain pipe. The installation of a U-shaped pipe can prevent the leakage of air-conditioning, the invasion of insects and mice.
12. Due to the wide variety of storage boards in the cold storage, the "Assembly Diagram of the Cold Storage" should be referred to when installing the mobile cold storage.
13. When tightening the hook, it should be applied slowly and evenly until the stitching of the board is closed. Do not use excessive force to prevent the hook box from being pulled out.
14. The cold storage should leave the heating appliances.
15. After the pipeline and electrical installation is completed, all pipeline perforations on the board of the combined cold storage must be sealed with waterproof silicone.
16. After the installation of the cold storage, sometimes condensation will appear before the concrete base is dry. In the rainy season and other times when the humidity is abnormally high, condensation will occur on the joints of the warehouse board, and in small cases, condensation will also occur on the refurbished warehouse board.
Yanghu professional engineers believe that the most important thing in cold storage installation is to be able to do the most basic things well, and to be able to put yourself in the shoes of customers. If you want to know more, you can call our hotline: 0519-88781801!
Latest news
NO.988 Shuichang Road, Henglin Town, Wujin District, Changzhou City, China.
0519-88787377
Follow us
Copyright © 2022 Changzhou Yanghu Refrigeration Equipment Co., Ltd.
0519-88781801 
Message 